Lishi 2 in 1 HU64 Mercedes user manual:
The Mercedes HU64 lock is a straightforward pick and decode process using the lishi 2in1 tool , door locks being far simpler to defeat than boot locks .
The lock is a 10 wafer lock with 5 cut heights referred to as heights 1 to 5 , 1 being the highest lift and 5 being the lowest lift , all 10 cuts are found in the door lock and in the boot lock.
You will notice that the tool has the 10 wafer positions , in 2 rows of 5 , an upper row and a lower row and follows a traditional 1 up and 1 down format . the grid to the right is the cut heights which will be obvious in the decode section of this guide.
There are no proven picking sequences with this lock at present , so its a matter of finding the binding wafer and picking it until bouncing tightly, until all wafers are picked and the lock opens .
The HU64 lock picks easiest in the locking direction and is a double lifter design of tool, and requires the lightest of tension for consistent success .
Excessive tension and overlifting is the most common cause of failure with this lock , the more tension that’s applied the higher the likelyhood of overlifting and the more likelyhood of damage to your tool , so very light tension is required for this tool.
Picking the HU64 lock
Fully insert the Lishi tool into the lock , apply a light tension and move one of the lifters to the first wafer , gently lift the wafer half a mm , if it moves then leave it alone and move on , try the next , any movement in the wafer at all , then leave it alone. When you find a binding wafer, lift until it has free movement again, a tight bounce i refer to as slapping. Every time you find a binding wafer , pick it until it slaps . once all binding wafers are set , the lock will open.
It is not unusual for a set wafer to drop out during the pick process , so expect to find a previously set wafer to bind again even after picking already .
A picture guide of the picking process is below.
Insert the tool fully and apply a light tension
Position 1 is the first to bind and pick
Position 3 is the next to bind and pick
Position 5 is the next to bind and pick
Position 9 is the next to bind and pick
Position 4 is the next to bind and pick
Position 6 is the next to bind and pick
Position 8 is the next to bind and pick
With a light tension and minimal effort, following a basic picking process this lock picks generally in a few minutes, remember a light tension is crucial for continued success.
Decoding the HU64 Lock using the lishi 2 in 1 locksmith tool
As the tool is of the double lifter design , this means that we decode in the same direction as we picked the wafer , so we use the same lifting arm to decode and decode in the same direction as picked.
In order to decode the HU64 lock , the lock must be held in the picked position , so after picking , maintain tension , holding the lock in the picked position , then lift the arm along each numbered line in turn until it comes to a stop, when it stops look along the height line to see the cut height required.
Follow the decode process below.
Position 1 reads as a No 3 cut
Position 2 reads as a No 2 cut
Position 3 reads as a cut No 3
Position 4 reads as No 2 cut
Position 5 reads as a No 2 cut
Position 6 reads as a No 3 cut
Position 7 reads as a No 5 cut
Position 8 reads as a No 5 cut
Position 9 reads as a No 2 cut
Position 10 reads as a No 5 cut
So the key for this lock read from bow to tip as 3232235525
Job’s done with a Lishi 2 in 1 HU64!